Table of Contents
Advertisement
1.13 U: Monitor Parameters
1.13 U: Monitor Parameters
Monitor parameters let the user view various aspects of drive performance using the HOA keypad display. Some monitors
can be output from terminals FM and AM by assigning the specific monitor parameter number (Uo-oo) to H4-01 and H4-04.
Refer to H4-01, H4-04: Multi-Function Analog Output Terminal FM, AM Monitor Selection on page 103
assigning functions to an analog output.
u
U1: Operation Status Monitors
Status monitors display drive status data such as output frequency and output current.
Monitors on page 248
for a complete list of U1-oo monitors and descriptions.
u
U2: Fault Trace
Use these monitor parameters to view the status of various drive aspects when a fault occurs.
This information is helpful for determining the cause of a fault.
U2-oo monitors and descriptions.
U2-oo monitors are not reset when the drive is initialized.
on how to reset these monitor values.
Note:
Fault histories are not kept when CPF00, CPF01, CPF06, CPF24, oFA00, oFb00, oFC00, Uv1, Uv2, or Uv3 occur.
u
U3: Fault History
These parameters display faults that have occurred during operation as well as the drive operation time when those faults
occurred.
Refer to U3: Fault History on page 251
U3-oo monitors are not reset when the drive is initialized.
on how to reset these monitor values.
Note:
Fault histories are not kept when CPF00, CPF01, CPF06, CPF24, oFA00, oFb00, oFC00, Uv1, Uv2, or Uv3 occur.
u
U4: Maintenance Monitors
Maintenance monitors show:
• Runtime data of the drive and cooling fans and number of Run commands issued
• Maintenance data and replacement information for various drive components
• kWh data
• Highest peak current that has occurred and output frequency at the time the peak current occurred
• Motor overload status information
• Detailed information about the present Run command and frequency reference source selection
Refer to U4: Maintenance Monitors on page 252
u
U5: PID Monitors
These monitors display various aspects of PID control.
monitors display PID data.
Refer to U5: PID Monitors on page 254
u
U6: Operation Status Monitors
These monitors display reference data for the output voltage and vector control and the offset value added to the frequency
reference by the frequency offset function.
Refer to U6: Operation Status Monitors on page 255
u
U9: Power Monitors
The total consumed power and regenerated power are displayed for these parameters.
256
for a complete list of U9-oo monitors and descriptions.
164
Refer to U2: Fault Trace on page 250
Refer to o4-11: U2, U3 Initialization on page 139
for a complete list of U3-oo monitors and descriptions.
Refer to o4-11: U2, U3 Initialization on page 139
for a complete list of U4-oo monitors and descriptions.
Refer to PID Block Diagram on page 34
for a complete list of U5-oo monitors and descriptions.
Refer to Settings 44, 45, and 46: Offset Frequency 1, 2, 3 on page 85
for a complete list of U6-oo monitors and descriptions.
YASKAWA ELECTRIC SIEP C710636 10C Z1000U HVAC MATRIX Drive Programming Manual
for details on
Refer to U1: Operation Status
for a complete list of
for instructions
for instructions
for details on how these
Refer to U9: Power Monitors on page
for details.
Advertisement
Table of Contents
