Level Refrigerator; Adjust Doors - Thermador KBUIT4250A Installation Instructions Manual

5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
2
1. Top grille
2. Cabinet side trim
L evel Re f r i g e rat o r
NOTE: Custom or full-overlay door panels must be installed
before leveling the refrigerator.
1. Open the doors and place the level on top of the refrigerator
frame as shown. Check to see whether the refrigerator is level
from left to right.
1
2
1. Level to check left to right leveling
2. Level to check front to back leveling
2. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from left to right.
1
2
1. Rear leveling bolt
2. Front level bolt
3. Place the level(s) on shelf or shelves as shown. Check to see
whether the refrigerator is level from front to back.
4. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from front to back.
5. Be sure that all 4 leveling legs contact the floor and support
the full weight of the refrigerator.
6. Make final check to ensure the refrigerator is level.
1 2
2
A d j u s t D o or s
Door Height Adjustment
Use the following steps to adjust the door height, up or down,
after the doors have been leveled.
1. Open the freezer or refrigerator door. Remove the door stop
screw the bottom side of the bottom hinge.
2. Remove the locking plate as shown.
3. Turn the bushing located underneath the bottom of the hinge
using the open-end wrench. Turning the bushing to the left
(counterclockwise) will raise the door. Turning the bushing
right (clockwise) will lower the door.
4. After adjusting, check the doors to make sure they are even
at the top and bottom. If the doors are not even, continue to
turn the bushing to adjust the door height.
5. Replace the locking plate.
1
6. Turn the bushing slightly to align the hinge and locking plate
2
screw holes.
7. Replace the door stop screw or screws and tighten.
8. Recheck to make sure the doors are aligned and even.
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide or you are installing full-overlay custom
panels using a Trimless Trim Kit, you should adjust the door
swing.
2. Remove the door stop screw or screws (depending on your
model) from the bottom hinge. See "Door Height Adjustment"
earlier in this section.
3. Hold the door open to a position that is less than 90°.
1 2 3
1. Bushing
2. Door stop screw
3. Locking plate
21