Custom Panel Series Side Panels - Thermador KBUIT4250A Installation Instructions Manual

C us t om Pan el Se r i e s
S i d e Pa ne l s
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
The dimensions shown are actual product dimensions
and may not reflect the needed installation dimensions.
The side panel should be a minimum of
thick to prevent warping.
If the opening depth is 25 in. (63.5 cm) or more, you may
want to install a support board on rear wall.
Refrigerator
14
in. (12 mm)
Overlay
23 3 / "
8
(59.40 cm)
Side Trim
3 / "
8
(9.7 mm)
1 / "
16
(1.5 mm)
1
/ "
8
(3.2 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add in. (0.8 mm) to this measurement to allow the
side panel to fit into the trim.
2. If the panel is more than
edge to allow the side panel to fit into the trim.
A
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a
(9.5 mm) board to hold the panel in the cabinet side trim.
A
3 / "
16
(4.5 mm)
in. (9.5 mm) thick, route the front
in.