Level Refrigerator; Adjust Door Swing - Thermador KBULT3651A Installation Instructions Manual

Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel side down on a soft working surface.
2
1. Top grille
2. Cabinet side trim
3. Remove one end cap by loosening the nuts and sliding off the
end cap.
1. Bottom rail
2. Nuts
4. Slide the decorative panel into the top grille channel and
reattach the end caps.
1. Backer panel
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
2
1. Top grille
2. Cabinet side trim
18
1 2
3. End cap
4. Top rail
1 2
L eve l Re f r i g e rat o r
NOTE: Custom or full-overlay door panels must be installed
before leveling.
1. Open the door and place the level on top of the refrigerator
frame as shown. Check to see whether the refrigerator is level
from left to right.
1
2
1. Level to check left to right leveling
2. Level to check front to back leveling
2. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from left to right.
1
2
1. Rear leveling bolt
2. Front level bolt
3. Place the level(s) on shelf or shelves as shown. Check to see
whether the refrigerator is level from front to back.
4. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from front to back.
5. Be sure that all 4 leveling legs contact the floor and support
the full weight of the refrigerator.
6. Make final check to ensure the refrigerator is level.
A d j u s t D o or S w i ng
1. Check that the refrigerator door can open freely. If the door
opens too wide or you are installing full-overlay custom
panels using a Trimless Trim Kit, you should adjust the door
swing.
2. Remove the door stop screw from the bottom hinge.
1 2 3
1. 130°
2. 110°
3. 90°
1
2