Changing A Particular Option; Setting Discharge Temperature Control - Samsung MCM-D201N Installation Manual

Changing a particular option

You can change each digit of set option.
Option SEG1
Explanation PAGE
Remote
Controller
Display
Indication Details
Indication
and
0
Details
• When changing a digit of an AHU KIT address setting option, set the SEG3 as 'A' .
• When changing a digit of an AHU KIT installation option, set the SEG3 as '2' .
NOTE
Ex) When setting the 'buzzer control' into disuse status.
Option
Explanation
Indication

Setting discharge temperature control

1. In service mode of a wired remote control, you can set whether to use "Discharge temperature control" or not and also
can set targeted temperature of heating and cooling. Refer to "Installation/service setting mode" in a wired remote
controller's installation manual.
2. If you set to use "Discharge temperature control", a thermostat of a product is turned on or off according to room set
temperature and room temperature. Discharge temperature control is carried out while thermostat is on.
❋ The discharge temperature control can be set using DMS, also.
❋ Discharge temperature may not meet the desired temperature(set value) depending on conditions of the external air.
3. When the discharge temperature control is used, SEG21 of 01 series installation option must be set as "1".
28
SEG2 SEG3
Option mode to
MODE
change
Indication Details Indication
Option
D
mode
SEG1 SEG2
PAGE MODE
0 D
SEG4
Tens' digit of an
option SEG to
change
Details Indication Details
Tens'
0~F digit of 0~9
SEG
SEG3 SEG4
Tens' digit of
Option mode
an option SEG
to change
to change
2 1
SEG5 SEG6
Unit digit of an
option SEG to Changed value
change
Indication Details Indication
Unit
Changed
digit of 0~9
value
SEG
SEG5 SEG6
Unit digit of an
option SEG to Changed value
change
7
Details
0~9
1