Changing A Particular Option - Samsung AM NJD Series Installation Manual

SEG 3, 4, 5, 6, 8, 9 additional information
When the SEG 3 is set as "1" and follow Auto Change Over for HR only operation, it will operate as follows.
Temp.
Ts
Set temp.
for Auto mode
Cooling/Heating mode can be changed when Thermo Off status is maintained during the time with SEG9.

Changing a particular option

You can change each digit of set option.
Option SEG1
Explanation PAGE
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
Indication
and Details
0
Note
• When changing a digit of an indoor unit address setting option, set the SEG3 as 'A' .
• W hen changing a digit of indoor unit installation option, set the SEG3 as '2' .
Ex) When setting the 'buzzer control' into disuse status.
Option SEG1
Explanation PAGE
Indication 0
 If you are using heat pump model, mixed operation mode (two or more indoor units operating in different operation
mode simultaneously) is not available when the indoor units are connected to same outdoor unit. If you set the master
indoor unit with a remote controller, outdoor unit will operate in the mode which was set in the master indoor unit.
Standard temp. for
Heating → Cooling
b
Standard temp.
for Cooling
d
Standard temp.
for Cooling →
Heating
SEG2 SEG3
The option mode
MODE
you want to change
Option
D
mode
SEG2 SEG3
The option mode you
MODE
want to change
D 2
c
B C
A D
a
Standard temp.
for Heating
A : Set with SEG4(˚C)
B : Set with SEG5(˚C)
C : Set with SEG6(˚C)
D : Set with SEG8(˚C)
SEG4
The tens' digit of an
option SEG you will
change
Tens' digit
1~6 0~9
of SEG
SEG4
The tens' digit of an The unit digit of an
option SEG you will option SEG you will
change
1
SEG5 SEG6
The unit digit of an
option SEG you will Changed value
change
The
Unit digit
0~9 changed
of SEG
value
SEG5 SEG6
Changed value
change
7 1
0~F
27