Teledyne 3160 Operating Instructions Manual page 53

12. After checking for the modem, pressing ESC returns
you to status page seven in step 10.
If INIT was pressed in status page 7 and then SETUP
pressed in step 11, pressing ACK will return you to this
screen. Press ESC to return to status page seven in step
10.
13. If you have purchased the parallel printer option, status
page eight allows for configuration of the port. Press
EDIT to change the configuration.
• Mode Mode: ON/OFF Mode
Mode Mode
• Interval: 3–32000 seconds Interval Interval
Interval Interval
NOTE: NOTE: NOTE: The printer report will always be in the same for- NOTE: NOTE: The printer report will always be in the same for- The printer report will always be in the same for- The printer report will always be in the same for- The printer report will always be in the same for-
mat—O mat—O
mat—O mat—O mat—O
14. After pressing EDIT, a cursor will appear and you will
be able to edit the settings.
15. Status page nine shows whether or not the last and next
start-ups were WARM or COLD. The next start-up may
be changed by pressing the COLD or WARM keys.
16. Status page ten displays logger data. Press VIEW to see
the logger data history. Press NEXT to return to status
page one. Press ESC twice to return to the Analyze
mode main menu.
17. If VIEW was pressed in step 13, logger data may be
viewed by using the +, –, REV and FWD keys. The O
level, range, and time are shown for each data point.
NEXT takes you to status page two.
REV and FWD change the date by one page (or 64
points), while – and + go through the data one point at a
time within a single page. Press ESC to return to status
page ten.
TELEDYNE ANALYTICAL INSTRUMENTS
Level, Range, Active Sensor, Time & Date. Level, Range, Active Sensor, Time & Date.
Level, Range, Active Sensor, Time & Date. Level, Range, Active Sensor, Time & Date. Level, Range, Active Sensor, Time & Date.
2 2 2 2 2
Operations 4 Operations 4
Operations 4 Operations 4 Operations 4
2
4-25