Drill Master XP User Manual page 48

2.
Alignment Button
Alignment
Port
118˚
3.
4.
46
Insert Chuck into
Alignment Port
Drill Stop
the Chuck. While holding the
button down, slide the drill bit for-
ward until it touches the Drill Stop
and the Chuck is pushed all the way
into the Alignment Port. Release the
Alignment Alignment Button.
Alignment
Guide
Adjust Bit Position
Look at your bit and make sure the Bit
Clamp Arms are in the bit's narrowest
spot. If they aren't, turn the bit in
the chuck so that it is held by the Bit
Clamp Arms at its narrowest width.
This is important because this setting
determines the angle at which your bit
will be sharpened.
Bit Clamp Arms
Drill Stop
Tighten Chuck
Hold onto the Chuck and tighten the
Chuck Knob. (Avoid over-tightening
the Chuck in the Alignment Port. This
could damage the Chuck and Port.)
Press the Alignment
Button down and hold
it. Match the either of
the Alignment Guides
on the Chuck with
the 118° Notch on the
Alignment Port. Insert
www.drilldoctor.de