Table of Contents
Advertisement
Identifier
Status
Rimozione della base del computer
AVVERTENZA: Prima di effettuare interventi sui componenti interni del computer, leggere le informazioni sulla
sicurezza fornite con il computer e seguire la procedura in
computer. Dopo gli interventi sui componenti interni del computer, seguire le istruzioni descritte in
interventi sui componenti interni del
sicurezza, consultare la home page Conformità alle normative su www.dell.com/regulatory_compliance.
Identifier
Status
Prerequisites
1
Remove the
base
cover.
2
Remove the battery.
3
Remove the
wireless
4
Remove the
solid-state drive
5
Remove the
rear-I/O
Identifier
Status
Procedure
1
Using the pull tab, disconnect the hard-drive cable.
2
Remove the hard-drive cable from the routing guides on the computer base.
3
Disconnect the tobii cable from the system board.
4
Remove the antenna cables from the routing guides on the computer base.
5
Peel off the tobii cable from the system board.
6
Remove the screw (M2x3) that secures the display-cable bracket on the system board.
7
Lift the display-cable bracket off the system board.
8
Using the pull tab, disconnect the display cable from the system board.
9
Disconnect the camera cable from the system board.
GUID-9688293F-8D74-48E4-A8DD-4696624BAD12
Translated
computer. Per maggiori informazioni sulle procedure consigliate relative alla
GUID-B1C7ECFD-E703-4A0C-8D68-FA48D35100CB
In Translation
card.
(in SSD1 slot).
cover.
GUID-FD0067C1-D950-4927-9AFE-39BA0CC77330
In Translation
Prima degli interventi sui componenti interni del
Dopo gli
65
Advertisement
Table of Contents
