TANDBERG Gatekeeper User Manual page 74

xconfiguration Gatekeeper CallsToUnknownIPAddresses:
<Off/Direct/Indirect>
Specifies whether or not the Gatekeeper will attempt to call systems which are not registered with it or
one of its neighbor gatekeepers. Options are:
Allows an endpoint to make a call to an unknown IP address without the
Direct
Gatekeeper querying any neighbors. The call setup would occur just as it would if
the far end were registered directly to the local system.
Upon receiving a call to an unknown IP address, the Gatekeeper will query its
Indirect
neighbors for the remote address, relying on the response from the neighbor to
(default)
allow the ability for the call to be completed; connecting through the routing rules
as it would through the neighbor relationship.
This will not allow any endpoint registered directly to the Gatekeeper to call an IP
Off:
address of any system not also registered directly to that Gatekeeper.
See Unregistered Endpoints (section 6) for further detail. The default is Indirect.
xconfiguration Gatekeeper CallTimeToLive: <60..65534>
Specifies the interval in seconds at which endpoints are polled to verify that they are still in a call. The
default is 120 seconds.
xconfiguration Gatekeeper DNSResolution Mode: <On/Off>
Determines whether or not DNS lookup of H.323 URIs is enabled on this system. The default is On.
xconfiguration Gatekeeper Downspeed PerCall Mode: <On/Off>
Determines whether or not the system will attempt to downspeed a call if there is insufficient per-call
bandwidth configured to fulfill the request. The default is On.
xconfiguration Gatekeeper Downspeed Total Mode: <On/Off>
Determines whether or not the system will attempt to downspeed a call if there is insufficient total
bandwidth available to fulfill the request. The default is On.
xconfiguration Gatekeeper ForwardLocationRequests: <On/Off>
Determines behavior on receipt of a location request (LRQ) from another Gatekeeper. If set to On, the
Gatekeeper will first try to resolve the request locally. If it cannot, the request will be forwarded to
neighbor Gatekeepers. The default is On.
xconfiguration Gatekeeper LocalDomain DomainName: <name>
Specifies the DNS name of the domain that the Gatekeeper is responsible for. Used when searching for
matching endpoint registrations.
xconfiguration Gatekeeper LocalPrefix: <prefix>
Sets the local zone prefix of the system.
xconfiguration Gatekeeper Policy Mode: <On/Off>
Determines whether or not the CPL policy engine is active. The default is On.
TANDBERG Gatekeeper User Guide
Page 74 of 105