Command; Allowlistadd; Allowlistdelete; Boot - TANDBERG Gatekeeper User Manual

16.3.

Command

The command root command, xcommand, is used to execute commands on the Gatekeeper.
To list all xcommands type:
xcommand ?
To get usage information for a specific command, type:
xcommand <command_name> ?
16.3.1.
xCommand AllowListAdd <allowed_alias>
Adds an entry to the allow list, used by the registration restriction policy.
allowed_alias can either be a specific alias, or use the wildcards ? (for a single character) and *
(for a single character or string of characters) to pattern match a group of possible aliases.
16.3.2.
xCommand AllowListDelete <index>
Removes the pattern with the specified index from the allow list.
Allow list entries can be viewed using the command xconfiguration Gatekeeper
Registration AllowList.
16.3.3.
xCommand Boot
Reboots the Gatekeeper. This takes approximately 2 minutes to complete.
16.3.4.
xCommand CallTransfer Call:<call_index> Leg: <1/2> Alias: <alias>
Attempts to transfer the half of the call identified by the call index and leg to the given alias.
Call and leg indices may be identified using xstatus calls.
16.3.5.
xCommand CheckBandwidth <node1> <node2> <bandwidth> <calltype>
This is a diagnostic function for verifying bandwidth control.
Node1
Node2
bandwidth
calltype
16.3.6.
xCommand CredentialAdd <username> <password>
Adds the given username and password to the local authentication database.

AllowListAdd

AllowListDelete

Boot

CallTransfer

CheckBandwidth

The case-sensitive names of the nodes.
The required bandwidth.
Must be one of Traversal, Routed or Direct

CredentialAdd

TANDBERG Gatekeeper User Guide
Page 84 of 105