Acquisitioncontrol; Digitaliocontrol - Omron STC-SBE132POE Product Specifications And User's Manual

AcquisitionControl

Name
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionFrameCount
AcquisitionFrameRate
TriggerSelector
TriggerMode
TriggerSoftware
TriggerSource
TriggerActivation
TriggerDelay
ExposureMode
ExposureTime
ExposureTimeAbs
ExposureTimeRaw
ExposureAuto

DigitalIOControl

Name
LineDebounceTime
LineSource0
LineSource1
UserOutputValue0
UserOutputValue1
StrobeSignalDelay
StrobeSignalOnTime
LineInverter0
LineInverter1
STC-SBE132POE / STC-SCE132POE
Product Specifications and User's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
Description
Sets the acquisition mode of the device. It defines mainly the number of frames to
capture during an acquisition and the way the acquisition stops.
Starts the Acquisition of the device. The number of frames captured is specified by
AcquisitionMode.
Stops the Acquisition of the device at the end of the current Frame. It is mainly used
when AcquisitionMode is Continuous but can be used in any acquisition mode.
Number of frames to acquire in MultiFrame Acquisition mode.
Controls the acquisition rate (in Hertz) at which the frames are captured.
Selects the type of trigger to configure.
Controls if the selected trigger is active.
Generates an internal trigger. TriggerSource must be set to Software.
Specifies the internal signal or physical input Line to use as the trigger source. The
selected trigger must have its TriggerMode set to On.
Specifies the activation mode of the trigger.
Specifies the delay in microseconds (us) to apply after the trigger reception before
activating it.
Sets the operation mode of the Exposure (or shutter).
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
Sets the automatic exposure mode when ExposureMode is Timed. The exact algorithm
used to implement this control is device-specific.
Description
Sets the value of the input line debouncer time.
Set the output signals from the power / IO connector.
Set the output signals from the power / IO connector.
Sets the value of the bit selected by LineSource0.
Sets the value of the bit selected by LineSource1.
Specifies the delay in microseconds (us) to apply the trigger reception before activating
strobe signal.
Specifies the strobe signal active time in microseconds (us).
Controls the invertion of the signal of the selected output line of LineSource0.
Controls the invertion of the signal of the selected output line of LineSource1.
No.14S002-08
46/53