Usersetcontrol; Ipengine - Omron STC-SBE132POE Product Specifications And User's Manual

Name
GevMCTT
GevMCRC
GevMCSP
GevStreamChanelSelector
GevSCPDirection
GevSCPInterfaceIndex
GevSCPHostPort
GevSCPFireTestPacket
GevSCPSDoNotFragment
GevSCPSBigEndian
GevSCPSPacketSize
GevSCPD
GevSCDA
GevSCSP

UserSetControl

Name
UserSetSelector
UserSetLoad
UserSetSave
UserSetDefaultSelector

IPEngine

Name
ProgrammableLogicController
STC-SBE132POE / STC-SCE132POE
Product Specifications and User's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
Description
Provides the transmission timeout value in miliseconds.
Controls the number of retransmissions allowed when a message channel message
time out.
This feature indicates the source port for the message channel.
Selects the stream channel to control.
Reports the direction of the stream channel.
Index of network interface to use.
Controls the port of the selected channel to which a GVSP transmitter must send data
stream or the port from which a GVSP receiver may receive data stream.
Sends a test packet.
The state of this feature is copied into the "do not fragment" bit of IP header of each
stream packet.
Endianess of multi-bytes pixel data for this stream.
Specifies the stream packet size, in bytes, to send on the selected channel for a GVSP
transmitter or specifies the maximum packet size supported by a GVSP receiver.
Controls the delay (in timestamp counter unit) to insert between each packet for this
stream channel.
Controls the destination IP address of the selected stream channel to which a GVSP
transmitter must send data stream or this destination IP address from which a GVSP
receiver may receive data stream.
Indicates the source port of the stream channel.
Description
Selects the feature User Set to load, save or configure.
Loads the User Set specified by UserSetSelector to the device and makes it active.
Save the User Set specified by UserSetSelector to the non-volatile memory of the
device.
Selects the feature User Set to load and make active by default when the device is
reset.
Description
Category that contains the Programmable Logic Controller (PLC) features.
No.14S002-08
49/53