Chicco Fit 4 User Manual page 37

INSTALL USING LAP-SHOULDER BELT
While pushing down on the Child Restraint (a) pull the vehicle shoulder
4
belt (b) to tighten vehicle lap belt.
5
While still pulling the shoulder belt tight, slide the vehicle shoulder belt
into the Lock-Off. Always use the Lock-Off on the opposite side of the
vehicle belt buckle.
CHECK YOUR WORK

Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Vehicle belt should remain tight and Child Restraint should
not move more than 1" (25 mm) from vehicle seat back or side-to-side.

Make sure Child Restraint is level for REAR-FACING use. Make sure infant's head
does not fall forward. If necessary, loosen the vehicle belt, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.

Check installation before every use!
70
INSTALL USING LAP-SHOULDER BELT
5
4a
4b
71