Tilt Over Angle (Menu => Setup => Tilt Over Angle); Calibration (Menu => Setup => Calibration) - Honeywell HWC-S363-RV Instruction Manual

5.5 Tilt Over Angle (MENU => Setup => Tilt Over Angle)
This option is used to set the limit of the horizontal view angle so that the trim ring or
ceiling does not obstruct the horizontal image when zooming out (wide angle).
ON: In some installations it is desirable for the dome camera to be able to see above the
horizon. When this option is chosen, the dome will tilt up over the horizon(About 10
degrees). When the lens is zoomed out, you can see the ceiling line. But when the lens is
zoomed in, the viewing angle is narrower, and the ceiling line disappears.
Without Bubble: The tilt range of the camera is limited to see the horizon so the picture
shows part of the ceiling line.
With Bubble: The tilt range of the camera is limited to see below the horizon (- 10
degrees).
AUTO: automatic angle for zoom
5.6 Calibration (MENU => Setup => Calibration)
Origin Reset : Calibrate the ORIGIN point.
Origin Offset Move : Adjust the small amount of position error from re-installation.
Auto Calibration
VIEW ANGLE SETUP
Tilt Over Angle : W/O BUBBLE
Save And Exit
Calibration
Origin Reset
Origin Position Move
Origin Offset
Auto Calibration
Save And Exit
: The dome camera calibrates automatically when the deviation of
dome position by force or vibration is detected.(over 2 degrees)
: Disable
: OFF
38
PTZ SPEED DOME CAMERAS