Scan ( Menu => Function => Scan Or Shortcut: Scan) - Honeywell HWC-S363-RV Instruction Manual

releasing the SHFT/PGM key. This procedure can be repeated to reprogram the
pattern.
(Or twist zoom handle or hit zoom button to start PTZ control for view selection and hit
the Focus button to stop.)
5. Scroll down to the Exit option and move the Joystick to the right to exit.
6. Naming the Pattern can be done by twisting the Joystick. Rotate the handle
clockwise or counterclockwise to scroll through the alphanumeric characters, move
the handle to right or left to select next or previous space.
7. Pressing ESC will not save recorded data and will exit to the previous menu. Press
the HOME or OFF button at any programmed position to delete the programmed
pattern.
NOTE: If total recording time reaches 240 seconds, it will automatically stop for a moment
and start recording again. Previous data will be overwritten.
1.4 Scan ( MENU => Function => Scan or Shortcut: SCAN)
The Scan function supports up to 8 programmed sections of angles at 8 programmable
speeds.
SPEED (MODE):
Follow the steps below to program Scans.
1. Press the SCAN key to enter Auto Scan menu directly. (Or MENU => Function =>
Scan).
2. Select an Auto Scan number by moving the Joystick left or right.
3. Twist the Joystick to enter the title by scrolling through the alphanumeric characters
and move the handle to the right or left to move to the next space. Press ENTR key
or move the Joystick down to finish title mode.
4. When finish entering the title, select "Start" with the Joystick. Hold down the
SHFT/PGM key while selecting the start position using the Joystick. Current
panning position will be displayed. Release SHFT/PGM key to complete the
SCAN MENU
Scan 01
Speed
Start
End
Dir.
Swap
Save And Exit
1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
1: SLOWER ↔ 8 FASTER
01/08
: AUTOSCAN01
: 1~8
: 127.1, 027.0
: 157.7, 080.7
: CW
: OFF
22
PTZ SPEED DOME CAMERAS