Table of Contents
Advertisement
selection of the start position. (Or twist zoom handle or hit zoom button to start PTZ
control for view selection and hit the Focus button to stop.)
5. Move the Joystick downward to select "End." Hold down the SHFT/PGM key while
moving the Joystick to select the end position. The end position angle should be
larger than start position. Release the SHFT/PGM key to complete the selection of
the end position. (Or twist zoom handle or hit zoom button to start PTZ control and
hit the Focus button to stop.)
6. Move the Joystick downward to select "Tilt & Zoom." Set the zoom and tilt angle by
holding down the SHFT/PGM key.
7. Moving the Joystick downward to select "Speed" and set the speed by twisting the
Joystick clockwise or counterclockwise or move the Joystick left/ right to select
the auto scan speed.
8. Select Save and Exit by moving the Joystick to the right. Press ESC to exit the
program without saving.
Pressing the
HOME
1.5 Tour (or MENU => Function => Tour or ShortCut: TOUR)
There are 4 programmable Tours. Each Tour consists of up to 8 Preset positions, Patterns,
Scans or other Tours. Using second-level Tours, it can be expanded up to 56 functions in
a single Tour. However tours in the second level Tour will be ignored when called by the
first level Tour. This can be best illustrated by the following example:
Tour
If Tour 01 : Preset 02, Preset 03,Tour 02, Tour 03
Tour 02 : Preset 05, Preset 06,
Tour 03 : Preset 07, Pattern 01
Tour 04 : Preset 08. Preset 05, Pattern 01
Tour1 executes as follows:
Preset 02 Preset 03 Preset 05 Preset 06 Preset 05 Preset 07 Pattern 01
... (Repeat)
---Tour 04
Tour 02 executes as follows:
Preset 05 Preset 06 Preset 08 Preset 05 Pattern 01 Preset 05 ... Repeat
(Tour 04 is still valid if called directly from Tour 02.)
or
button to delete stored data, 000 will be displayed immediately.
OFF
Tour
in Tour 02 will be skipped in Tour 01
04, Preset 05
23
PTZ SPEED DOME CAMERAS
Advertisement
Table of Contents
