On The S100 Rear Panel - Symmetricom SyncServer S100 User Manual

On the S100 Rear Panel

Telephone
cable to wall
Connector
Complete the following steps to complete the S100 installation:
1. Connect the power cable to the S100.
GPS Option:
2.
Figure 3-3. Connect the Phone cord to a telephone line.
Note:
"Appendix E" on page 141
3. If you are not using a Rubidium oscillator, connect the D-BNC Signal Breakout Cable
(BC11576-1000) to the DB15 Connector shown in Figure 3-3. If you are using the S100
with an optional Rubidium oscillator, connect the external rubidium cable (furnished with
the Rubidium oscillator) from the DB9 Connector to the DB15 connector (see Figure 3-
3).
Note: The D-BNC Signal Breakout Cable BC11576-1000 has five connectors on it. The three
connectors labelled "Time Code Output", "Time Code Input", and "1 PPS Output" are
available for use with on the S100. The connectors labelled "Event Input" and "Heartbeat" are
not applicable for use on the S100.
22
Telephone cable
to phone
DB15 GPS Antenna
Connector
Figure 3-3: S100 Rear Panel Close-up
Install GPS Antenna by connecting it to the GPS Antenna connector shown in
The GPS antenna described in this manual has been replaced as described in
DB9 Connector
(optional)
Power Panel
S100 User Guide – Rev. D – June 2005
SyncServer S100