Setting Up The Hardware; On The S100 Front Panel - Symmetricom SyncServer S100 User Manual

Setting Up the Hardware

On the S100 Front Panel

Complete the following steps before turning on the power:
Connect the 9-pin serial cable from the PC workstation to the S100 serial port. You are
1.
doing this so to configure the S100 using a PC; see
on page 24
2. Connect the RJ45-terminated Ethernet cable to one or both network ports on the S100.
Note:
two USB ports are not functionable on this S100 release.
outputs UTC only.
S100 User Guide – Rev. D – June 2005
Figure 3-2: S100 Front Panel Close-up
in the next section.
If only one network connection is required, use the
"Establishing A Serial Connection"
left
Ethernet port (
Sysplex Timer
Port: This port
2
3
eth0
). The
5
21