Setting Up The Ip Address - Symmetricom SyncServer S100 User Manual

7. Click OK.
8. In the terminal emulation (e.g., hyperterminal) window, select File->Properties. The
"Properties" dialog opens. Click Settings tab. Verify the Telnet Terminal ID is set
VT100
at
9. Click OK.
Note:
dow you should see the following :

Setting Up the IP Address

1. Power on the S100 unit. The Linux system boots. Various bootup data scrolls on the
terminal emulator's (e.g., Hyperterminal) screen. This may last a few minutes. When
prompted,
symmetricom <Enter>.
Note:
appears at the prompt interrupting the boot process. Use your backspace key to delete the
"e". Then press <Enter>. This will continue the bootup process. If using Tera Term or other
terminal emulation program, this anomaly may not occur. For security purposes, the root,
superuser
or
this, see
Keep your newly created password in a safe and secure place. If you should lose it, there is
NO PASSWORD RECOVERY capability with the S100. This means that you will have to
send the S100 back to Symmetricom for recovery!
2. Additional Linux boot-up data appears. When prompted, enter the Login and Password.
Type each one and press <Enter>.
26
Figure 3-5: COM Port Properties
* To set the Terminal Type, select File>Properties>Settings.
.
When your Hyperterminal is connected and operational, at the bottom of the win-
at the User ID login,
The following anomaly occurs when using Hyperterminal in WIN 95: "boot: e"
, password should immediately be changed using the passwd utility. To do
"How to change the root password" on page 115.
syncserv1 login:
Password:
type:
root <Enter>. At the Password prompt,
SyncServer S100
S100 User Guide – Rev. D – June 2005
type: