Locations And Functions Of Parts - Sony HDC2000 Operation Manual

Locations and Functions of Parts

Right Side and Left Side
Left side
AUDIO IN 1 AUDIO IN 2
MIC MIC
LINE +48V LINE +48V
OFF OFF
AES/EBU
7 89 0 qa
a Up tally lamp
Lights when the camera receives a red tally signal.
When the CALL button on the MSU-1000/1500 Master Setup
Unit or the RCP-1000/1500-series Remote Control Panel is
pressed, the lamp lights if previously off or goes off if
previously on. The brightness of the lamp can be adjusted by
menu operation. Setting the UP TALLY switch on the rear
panel to OFF will keep the lamp from lighting.
To display the camera number, attach a supplied number plate
(0 to 9) or select the desired number on the menu.
b Safety lock
Locks the side panel to prevent accidental opening. To open
the side panel, loosen the side panel lock screws, slide the
safety lock towards the lens, and open the panel.
The side panel locks automatically when closed.
c Camera number plate
Attach a light gray number plate (supplied) to display the
camera number.
d Side panel lock screws
These screws secure the side panel. Turn clockwise until tight
to lock the panel.
e Lens lock and knob
These lock the lens. To attach or remove a lens, turn the knob
counterclockwise until the lens lock is horizontal. To secure
the lens, turn the knob clockwise until the lens lock is vertical.
Note
To attach a large lens, remove the pin from the bayonet mount
of the lens.
1
DC IN
qs
Right side
1
2
1
3
4
5
OUTPUT
6
SDI 1 SDI 2 SDI MONI TEST OUT
qdqfqgqh qjqk
f Cable clamp
To secure the fiber optic cable.
g AUDIO IN 1 switch
Set this switch according to the device connected to the
AUDIO IN 1 connector.
MIC: When connecting a microphone
LINE: When connecting the signal of line level (0 dBu)
h Microphone power switches
For the microphones connected to the AUDIO IN 1 and 2
connectors, respectively.
OFF: When the connected microphone requires no external
power.
+48 V: When the connected microphone requires an external
power source. A power of +48 V is supplied to the
microphone.
(No function has been assigned to the uppermost position. No
power is supplied to the microphone.)
Note
When supplying a power of +12 V, contact a Sony service
representative or a Sony representative.
i AUDIO IN 2 switch
Set this switch according to the device connected to the
AUDIO IN 2 connector.
MIC: When connecting a microphone
AES/EBU: When connecting a digital audio signal
synchronized with a camera signal
LINE: When connecting the signal for line level (0 dBu)
6
PROMPTER REMOTE CRANE TRACKER RET DC
1 2
CONTROL OUT
NETWORK
TRUNK
w;wa ws wd wf wg
ql