Attaching The 7.4-Type Viewfinder - Sony HDC2000 Operation Manual

Attaching the 7.4-Type Viewfinder

For details on attaching a viewfinder, refer to the operating
instructions supplied with the viewfinder.
Proceed as follows:
Notes
• Before attaching the viewfinder, be sure that the VF
connector on the viewfinder mount is positioned at a right
angle to the control panel of the camera as shown below.
• When attaching the viewfinder to the camera or removing it
from the camera, be sure to lock the viewfinder in its
standard position.
• When removing the viewfinder from the camera, be sure to
secure the tripod with its tilt-lock mechanism and hold the
viewfinder firmly.
Be careful not to fall or drop the viewfinder and camera.
For how to change the position of the viewfinder attached to
the camera, refer to the operating instructions of the
viewfinder.
1
Turn the panning base mounting plate of the camera
fully to the right, as illustrated in the figure below.
2
Hold the viewfinder so that the projection of the
panning base located at the bottom is positioned as
illustrated and insert the mounting wedge of the
viewfinder into the V-shaped recess of the camera's
panning base mounting plate.
Bottom of the
viewfinder
Panning base mounting plate
Viewfinder
connector
3
Press the base portion and insert the viewfinder fully
into the panning base mounting plate.
Pull the handle and check to ensure that the viewfinder is
securely locked.
Projection
Panning base
Mounting
wedge
V-shaped recess
Pan-friction
screw
4
Turn the viewfinder to a random position.
Handle
Base portion
Note
Make sure that the viewfinder is securely locked. If the
viewfinder is not properly attached to the camera, it may fall
and cause injuries.
To remove the viewfinder
1
Return the viewfinder screen to the standard position.
2
Fix the viewfinder screen in the standard position by
turning the tilt-lock knob and lift-lock knob in the
direction of the arrow indicated on each knob (toward
the lock position).
Standard position: The screen's height and position are fixed fully
back, as illustrated.
1
14
2
Tilt-lock knob
2
Lift-lock knob