Compaq SLT 386s/20 Maintenance And Service Manual page 71

3. Remove the shock mounts by grasping the center of the rails and pulling
the shock mounts straight out.
To replace the shock mounts, fixed disk drive enclosure, and fixed disk drive,
reverse the steps in the previous illustrations.
CAUTION: SHOCK MOUNTS MAY BEND WHEN REMOVED.
STRAIGHTENED BEFORE REPLACING THE SHOCK MOUNTS ON THE DRIVE.
IMPORTANT: When replacing the fixed disk drive, install the short screws to
the outside of the drive to prevent damage to the system board.
Removing the Flexible Ground Shield (COMPAQ SLT 386s/20 Only)
1. Remove the fixed disk drive assembly.
2. Remove the fixed disk drive enclosure and shock mounts.
3. Use a Torx T-15 screwdriver to remove the four screws securing the
flexible ground shield to the drive.
BE SURE THE PINS ARE