10/100/1000 Mb/S Tri-Speed Ethernet Phy - Xilinx AC701 User Manual

10/100/1000 Mb/s Tri-Speed Ethernet PHY

[Figure
The AC701 board uses the Marvell Alaska PHY device (88E1116R) at U12 for Ethernet
communications at 10 Mb/s, 100 Mb/s, or 1,000 Mb/s. The board supports RGMII mode only. The
PHY connection to a user-provided ethernet cable is through a Halo HFJ11-1G01E RJ-45 connector
(P4) with built-in magnetics.
On power-up, or on reset, the PHY is configured to operate in RGMII mode with PHY address
0b00111 using the settings shown in
passed over the MDIO interface.
Table 1-15: Ethernet PHY U12 Configuration Pin Settings
AC701 Evaluation Board
UG952 (v1.4) August 6, 2019
1-2, callout 14]
U12 Pin Name (No.)
CONFIG0 (64)
CONFIG1 (1)
CONFIG2 (2)
CONFIG3 (3)
www.xilinx.com
Table 1-15. These settings can be overwritten by commands
Setting
VCCO1V8 PHYAD[1]=1
PHY_LED0 PHYAD[3]=0
GND ENA_XC=0
PHY_LED0 ENA_XC=0
VCC1V8 ENA_XC=1
GND RGMII_TX=0
PHY_LED0 RGMII_TX=0
PHY_LED1 RGMII_TX=1
VCC1V8 RGMII_TX=1
Feature Descriptions
Configuration
PHYAD[0]=1
PHYAD[2]=1
PHYAD[4]=0
PHYAD[4]=1
PHYAD[4]=1
RGMII_RX=0
RGMII_RX=1
RGMII_RX=0
RGMII_RX=1
Send Feedback
41