10/100/1000 Mhz Tri-Speed Ethernet Phy; Ethernet Phy Reset; Ethernet Phy Led Interface; Ethernet Phy Led Functional Description - Xilinx Zynq UltraScale+ ZCU216 User Manual

10/100/1000 MHz Tri-Speed Ethernet PHY

[Figure 2, callout 16]
The ZCU216 board uses the TI DP83867IRPAP Ethernet RGMII PHY (U33) (see
Instruments website) for Ethernet communications at 10 Mb/s, 100 Mb/s, or 1000 Mb/s. The
board supports RGMII mode only. The PHY connection to a user-provided Ethernet cable is
through a Wurth 7499111221A RJ-45 connector (P1) with built-in magnetics.

Ethernet PHY Reset

The DP83867IRPAP PHY U33 reset circuit is shown in the following figure. The DP83867IRPAP
can be reset by the GEN3_EXP_RESET_B signal through the I2C0 TCA6416A U15 bus expander
P06 pin 10 or the PS_POR_B signal generated by the MAX16025 U6 POR device pin 11.
SW4 pushbutton at the MAX16025 U5 pin 6 input also triggers a PS_POR_B signal.

Ethernet PHY LED Interface

[Figure 2, callout 16]
The DP83867IRPAP PHY U33 LED interface (LED_0, LED_2) uses the two LEDs embedded in
the P1 RJ45 connector bezel. The LED functional description is as shown in the following table.
Table 16: Ethernet PHY LED Functional Description
Pin
Name Number
LED_2 61
LED_1 62
UG1390 (v1.1) July 10, 2020
ZCU216 Board User Guide
Figure 14: Ethernet PHY Reset Circuit
Type
By default, this pin indicates receive or transmit activity.
Additional functionality is configurable by means of LEDCR1[11:8] register bits.
S, I/O, PD
Note: This pin is a strap configuration pin for RGZ devices only.
By default, this pin indicates that 100BASE-T link is established.
S, I/O, PD
Additional functionality is configurable by means of LEDCR1[7:4] register bits.
Chapter 3: Board Component Descriptions
Description
Send Feedback
Texas
www.xilinx.com
42