Table of Contents
Advertisement
7. Perform the following settings as required.
Network Setting:
Date Setting:
Disc Registration Mode: Select whether to use RFID and disc registration method when disc BIN is
Professional Disc Drive: Select the number of disc drives to be used, and then click the [Update]
BIN RFID Setting:
Buzzer Setting:
Juke ID:
LCD Back Light:
Redundant Power Supply: When the optional power unit (XDBK-101) is added, select On.
Silent Mode:
8. Click the [Close] button to close the setup menu once.
9. Click the [Setup|Menu] button to display the setup menu, and check that the settings in step 7 are
refl ected.
10. Close the Web browser.
*1: The operation speed of this unit is slightly slowed down, accordingly, the operating noise will quiet down a little.
*2: To reboot, press the [Reboot] button, and then press the [Yes] button.
XDJ-1000
Type the IP address, subnet mask and default gateway, LinkSpeed (default:
"1 Gbps Full Duplex"), and JumboFrame (default: "Off (1514)"), and then
click the [Update] button and reboot
Type the date and time zone, and then click the [Update] button and
*2
reboot
.
installed from the following items, and then click the [Update] button to
reboot the unit.
. Use Disc Drive (no RFID)
RFID is not used. Information is acquired from the disc drive when
registering information in the disc.
. Use Disc Drive and RFID
RFID is used. Information is acquired from RFID and the disc drive
when registering information in the disc.
. Give priority to RFID
RFID is used. Information is acquired from RFID when registering
information in the disc. However, RFID acquires information from the
disc drive only in the initial state where no information exists in the
RFID. In this mode, discs from which RFID cannot read information are
not available.
button to reboot the unit. (When two disc drives are to be used, use the
option professional disc drive (XDBK-J102).)
Select whether to use the BIN's RFID, and then "click the [Update]
button to reboot the unit. However, if the Disc Registration Mode is set to
the state where RFID is not used, only "Off" setting is enabled.
Select whether or not to make the buzzer sound.
Type the ID of this unit, and then click the [Update] button and reboot
Select whether or not to turn on or off the LCD back light.
Select whether or not to set to the silent mode
*2
.
*1
.
*2
.
1-17 (E)
Advertisement
Table of Contents
