Sony XDCAM XDJ-1000 Installation Manual page 21

Attaching the outer rail
9. Temporarily secure the rail bracket at four portions
(front, rear, right and left) with the eight screws and
four plate nuts (small) to the position (space by 5U) of
the rack on which this unit is mounted as shown in the
illustration.
Space
by 5U
Rack
Rack angle
10. Securely tighten the eight screws to fi x the rail mount-
ing bracket at four portions which were temporarily
secured to the right and left outer rails in steps 7 and 8.
Tightening torque:
138 x 10
_2
N.m {14 kgf.cm}
XDJ-1000
Rail bracket
PSW
4 x 12
PSW
4 x 12
Plate nut (small)
PSW4 x 12
Outer rail
Plate nut
(small)
11. Check that the intermediate rails attached to both sides
are parallel to each other.
12. Securely tighten the eight screws to fi x the right and
left rails which were temporarily secured to the rack in
step 9.
Intermediate rails
Distance: A = A' = 426 mm
Mounting in rack
c
Be sure to carry the unit by the two persons or more.
13. Slide each ball retainer of intermediate rails on both
sides (left and right) in the direction of the arrow.
A
A'
Intermediate rail
Ball retainer
1-13 (E)