Sony XDCAM XDJ-1000 Installation Manual page 22

14. Draw the right and left intermediate rails to the lock
position.
15. Grasp the handles of the rack angles while holding the
unit from the bottom, insert the inner rails into the
intermediate rails, and then push them slowly as far as
it will go.
c
Be careful not to catch your fi nger or hand in rack
mount rail.
n
The intermediate rails locked in step 14 are pushed by
the inner rails and unlocked automatically.
Stoppers
Handle
of the rack angle
Handle of the rack angle
1-14 (E)
16. Slide the unit in and out from the rack about three
17. After the unit is installed in the rack, secure the unit to
Intermediate
rail
Inner rail
times and check that the slide rails move smoothly.
If they are not smoothly, demount the unit and go back
to step 7 ("Attaching the outer rails").
c
When demounting the unit, carry it by the two persons
or more.
n
This unit does not have the feet at this operating.
Put down the unit on the fl oor or other, being careful
not to damage the unit.
the rack with two screws (RK5 x 14) and two orna-
mental washers.
Tightening torque:
138 x 10
N.m {14 kgf.cm}
-2
Ornamental
washer
RK5 x 14
RK5 x 14
Ornamental
washer
XDJ-1000