Sony XDCAM XDJ-1000 Installation Manual page 19

Rack Mounting Procedure
Removing the feet
c
Be sure to carry the unit by the two persons or more.
1. Remove the four screws, lift the unit with both hands,
and then remove the four feet together with foot brack-
ets.
m
. Put the unit on an appropriate workbench when
removing and attaching the feet.
. Do not tilt the unit.
. Keep these screws, foot brackets and the feet.
When operating the unit after demounting it from the
rack, be sure to reattach the foot brackets and feet.
Tightening torque:
138 x 10
-2 N.m {14 kgf.cm}
B4 x 6
Feet
Foot brackets
Feet
XDJ-1000
Foot brackets
B4 x 6
Attaching the inner rails
2. Pull out the inner rails from the two intermediate rails.
3. While pressing the stopper of the inner rail in the
direction of the arrow A in the fi gure, pull the inner rail
out in the direction of the arrow B.
Intermediate rail
Inner rail
B
Stopper
4. Attach the two inner rails to both sides (left and right)
of unit with six screws.
Tightening torque:
138 x 10
N.m {14 kgf.cm}
-2
n
Be sure to use the screws (B4 x 6) when attaching the
inner rail.
The use other-sized screws may cause a malfunction.
Inner rail
B4 x 6
Outer rail
A
B4 x 6
Inner rail
1-11 (E)