Connecting Sata Drives; Removing Sata Drives; Figure 31. Attaching Sata Cables; Figure 32. Removing Sata Cables - Intel M10JNP2SB User Manual

9.9

Connecting SATA Drives

This section describes the process of attaching SATA power and data cables (not included) when connecting
SATA drives to the server board.
1. Connect one end of the SATA data cable connector to the drive (see letter A).
2. Connect the other end of the SATA data cable to one of the SATA ports on the board (see letter B). See
Section 7.2.1 for details on port location.
3. Connect the SATA power cable to the power connector of the drive (see letter C).
4. Connect the 4-pin power connector to the system power supply (see letter D).
The server board does not include power connectors for SATA drives. Power for SATA drives must be
provided through a cable harness (not included) routed to the system power supply.
9.10

Removing SATA Drives

This section describes the process of detaching SATA power and data cables (not included) when detaching
SATA drives from the server board.
1. Remove the end of the SATA data cable connected to the drive (see letter A).
Skip to step 3 if a replacement drive is being installed.
2. Remove the end of the SATA data cable from the server board (see letter B).
3. Remove the SATA power cable from the power connector of the drive (see letter C).
Skip step 4 if a replacement drive will is being installed.
4. Remove the 4-pin power connector to the system power supply (see letter D).
44
Intel® Server Board M10JNP2SB User Guide

Figure 31. Attaching SATA cables

Figure 32. Removing SATA cables