Quick Reference Table; Jumper Description; Connector Description - Supermicro H11SSL-I/C/NC User Manual

Quick Reference Table

Jumper Description
UID SW Unit ID switch (push-button toggle switch ON/OFF)
JBT1 Clear CMOS
JPB1 BMC Enable/Disable
JPG1 VGA Enable/Disable
JPS1 SAS Enable/Disable (H11SSL-C & H11SSL-NC only)
JWD1 Watch Dog control
JPL1, JPL2 LAN1, LAN2 Enable/Disable
LED Description
UID LED Rear unit ID LED
LEDM1 BMC heartbeat LED
LE1 Power OK LED
LE3 M.2 active LED
LEDSAS SAS port active LED
Connector
Battery (BT1)
JNCSI1
COM 1
FAN 1~5, A, B
IPMI_LAN
JF1
JSEN1
JSD1, JSD2
J23
JTPM1
I-SATA0~I-SATA7
L-SAS0~L-SAS7
SATA8~SATA11 (JNVME0)
SATA12~SATA15 (JNVME1)
JL1
JOH1
USB 0/1 (2.0)
USB 2/3 (2.0)
USB 4/5
USB 6/7
USB8
Status
Solid blue: UID switched to ON, unit identified
Green: Blinking (BMC normal), Green: Fast blinking (BMC initializing)
Green: System power OK
Green: M.2 PCI-E port active
Green: SAS port active (H11SSL-C & H11SSL-NC only)
Description
Onboard CMOS battery
NCSI header
Rear panel COM port #1
System cooling fan headers
Dedicated IPMI LAN port
Front control panel
Intel sensor header
SATA DOM power connector
M.2 PCI-E Interface
Trusted Platform Module (TPM)/Port 80 connector
Internal SATA Ports
Internal SAS Ports (H11SSL-C & H11SSL-NC only)
Internal SATA/NVMe Ports (SATA8~SATA11: H11SSL-i only, JNVME0: H11SSL-NC only)
Internal SATA/NVMe Ports (SATA12~SATA15: H11SSL-i only, JNVME1: H11SSL-NC only)
Chassis intrusion header
Chassis overheat header
Back panel USB 2.0 ports (USB 0/1)
Internal USB 2.0 header (USB 2/3)
Back panel USB 3.0 ports (USB 4/5)
Internal USB 3.0 header (USB 6/7)
Internal USB 3.0, Type A port (USB 8)
13
Chapter 1: Introduction
Default Setting
Off
Open (Normal)
Pins 1-2: (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
Pins 1-2 (Enabled)