Stopwatch; Connect - Suunto T6 User Manual

Wristop personal trainer with heart rate monitor

Hide thumbs Also See for T6:

Table of Contents

• Speed: Displays the speed in selected units (only if paired with a wireless speed

and distance sensor).

• Distance: Displays the distance from the beginning of the recording or lap (only if

paired with a wireless speed and distance sensor).

NOTE: If the altitude is not correct when the training starts, set it in the Alti/Baro

mode.

3.4.1. Stopwatch

With the stopwatch you can time your activities and record lap times. You can start

the stopwatch, stop it, and then restart it without having to reset it.

To use the stopwatch:

1. Press START/STOP to start the stopwatch.

2. Press UP/LAP to store lap/split times.

3. Press START/STOP to stop the stopwatch.

4. Long press UP/LAP to reset the stopwatch.

NOTE: When the stopwatch is on, the UP/LAP button is used for recording lap times

and the DOWN/LIGHT button switches between modes.

Connect is the first item in the Training menu. Press ENTER and choose Connect to

connect your Suunto t6 to the HR transmitter belt or a wireless speed and distance

sensor. Your Suunto t6 displays the message '

device. After this, the device informs you the device has been found. If the connection

fails, Suunto t6 displays the message '

transmitter belt fits snugly around your chest and the electrode area is wet or that the

wireless speed and distance sensor is switched on.

', while connecting to the

SEARCHING

NO DEVICES FOUND

'. Make sure the HR

Table of Contents