Table of Contents
Advertisement
S
S
UPER
ERVER 6012P-6 Manual
Floppy Drive
Figure 6-1.
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF2 connector on the motherboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF2 on the motherboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status.
System Interface" for details on the LEDs and the control panel buttons.
Details on JF2 can be found in "Chapter 5: Advanced Motherboard Installa-
tion."
Slim-Line CD-ROM Drive
SCSI Drives
Chassis: Front and Rear Views
6-2
System LEDs
Control Panel
NMI
System Reset
See "Chapter 3:
Main Power
Advertisement
Table of Contents
