Table of Contents
Advertisement
SUPERSERVER 6012P-6 User's Manual
!
POWER: This is the main power button, which is used to apply or turn
off the main system power.
removes the main power but keeps standby power supplied to the system.
3-3
Control Panel LEDs
The control panel located on the front of the SC812-SP chassis has five
LEDs. These LEDs provide you with critical information related to different
parts of the system. This section explains what each LED indicates when
illuminated and any corrective action you may need to take.
!
Overheat: Indicates an overheat condition in the chassis. This may
be caused by cables obstructing the airflow in the system or the ambient
room temperature being too warm.
that the chassis cover is installed and that all fans are present and operat-
ing normally. Verify that the heatsinks are installed properly (see Chapter
5).
Finally, check the air seals for damage.
pieces located to the left and right of the fans and against the front side of
the chassis frame cross section that separates the drive bay area from the
motherboard area of the chassis. There is also a small air seal positioned
between the two fans.
NIC2
!
NIC2:
Indicates network activity on LAN2 when flashing.
Turning off system power with this button
You should also check to make sure
3-2
The air seals are vertical
Advertisement
Table of Contents
