Table of Contents
Advertisement
SCSI Enable/Disable
The SCSI Termination jumper at
JP22 allows you to enable or dis-
able the onboard SCSI controller.
The normal (default) position is on
pins 1-2 to enable SCSI termina-
tion. See the table on the right for
jumper settings.
SCSI Termination Enable/
Disable
Jumpers JPA1 and JPA2 allow you
to enable or disable termination for
the individual SCSI channels.
Jumper JPA1 controls SCSI channel
A and JPA2 controls SCSI channel
B.
The normal (default) setting is
open to enable (teminate) both SCSI
channels.
If you wish to connect
external SCSI devices, you should
disable
termination
channnel(s) you will be connecting
them to. See the table on the right
for jumper settings.
Watchdog Enable/Disable
The WD jumper (located on JD1) al-
lows you to enableor disable the
Watchdog feature. The default po-
sition is open to disable the Watch-
dog timer.
When enabled, Watch-
dog can reboot your PC if an appli-
cation is "hung up" or the system
goes down.
See the table on the
right for jumper settings.
Chapter 5: Advanced Motherboard Setup
for
the
5-19
SCSI Enable/Disable
Jumper Settings
(JP22)
Jumper
Position
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
SCSI Channel T ermination
Enable/Disable
Jumper Settings
(JPA1, JPA2)
Jumper
Position
Definition
Open
Enabled
Closed
Disabled
W atchdog T imer Enable/
Disable Jumper Settings
(W D on JD1)
Jumper
Position
Definition
Open
Disabled
Closed
Enabled
Advertisement
Table of Contents
