Connecting The Control Panel - Supero SUPERSERVER 6012P-6 User Manual

S
UPERSERVER 6012P-6 User's Manual

Connecting the Control Panel

JF2 contains header pins for various front control panel connectors. See
Figure 5-3 for the pin locations of the various front control panel buttons
and LED indicators. Please note that even and odd numbered pins are on
opposite sides of each header.
All JF2 wires have been bundled into single ribbon cable to simplify their
connection. Make sure the red wire plugs into pin 1 as marked on the
board. The other end connects to the Control Panel printed circuit board,
located just behind the system status LEDs in the chassis.
See the Connector Definitions section in this chapter for details and pin
descriptions of JF2.
Figure 5-3. P4DPR-6GM+ Front Control Panel Header Pins
NMI
X
Power LED
HDD LED
NIC1 LED
NIC2 LED
Overheat LED
Power Fail Button
Ground
Ground
20 19
Ground
X
Vcc
Vcc
Vcc
Vcc
Vcc
Vcc
Reset Button
Reset
Power Button
Pwr
2 1
5-6