Kenwood TS-940S Instruction Manual page 9

TOP COVER
Slide lid opened
p
CAR FM MIG
Q)
LEVEL GAIN SUB
Dl~~
MEMORY
·~
"TID
~--~-
3
~o-~
:
- VOX CONTROLS
-~,
CAL
GAIN DELAY AN Tl OLQJF
~·
.. _?I_»PL"'
· · - ·5-
IO~Hl-
) -
SCALE
IMHz 100kHz
o-
0
4::Y
®
D
®
B
©
FRONT PANEL
REAR PANEL
6
3
(!)
5
6
7
CD
CAR LEVEL (carrier level) control
Used to adjust carrier level during CW.
®
FM MIC GAIN (microphone gain) control
Used to adjust microphone amplifier gain in FM.
®
Memory group selector switch
Allows to selection of the desired memory channel
group.
@ SUB DISP. CONTRAST control
Allows you to adjust the contrast of the sub display, us-
ing a (-) screwdriver.
®
CAL (marker) switch
When this switch is ON during reception, the
built-in oscillator will generate a marker signal at 1 00
kHz intervals. This switch is also used to zero beat the
internal oscillator frequency with a standard fre-
quency (WWV).
®
1 0 Hz indication switch
Allows frequency indication down to the nearest 1 0 Hz
digit.
(]) Analog SCALE selection switch
Used to select the analog scale range, 1 MHz or
100kHz.
(]:: VOX control
®
GAIN: Used to adjust VOX amplifier gain.
@ DELAY: Used to adjust delay time.
©
ANTI: Used so that VOX will not be actuated by the
internal speaker sound.