Kenwood TS-940S Instruction Manual page 21

NOTCH control@(page 22)---,
Used to attenuate interference caused
by heterodyne type signals. This con-
trol is not effective in reducing interfer-
ence caused by SSB, FM, or AM type
signals.
SQL (squelch) control®---......
Used to adjust squelch sensitivity.
Turning the control clockwise deepens
the squelch.
RF (RF gain) control®----....,
Used to control the gain of the high fre-
quency amplifiers. For normal opera-
tions this control should be full clock-
r : - - 1 1 - - - - - - - - - - - - - - - - - - 1
wise, for the greatest receiver sensitiv-
ity.
1:::::--~:::::1
-MEMORY
FUNCTION-
[][] 8 8 8 El
8 E3EH::~ ~
AF (audio gain) control®----.
Used to select the desired amount of
~=+----------------~
audio volume. Clockwise rotation in-
TRANSMISSION
CW VBT control @(page 21)
Used to control the effective CW pass-
" - - - - - - - - - f
bandwidth. Counterclockwise rotation
reduces the passbandwidth.
I]
Connect the RTIY keyboard to the RTIY jack on the
rear panel.
• Turn on the power.
IIJ
The meter lamp lights and a frequency is shown on
the display.
creases the volume.
• Set the MODE to FSK.
.-J
Set the METER switch to ALC.
llJ
Set the standby switch to SEND.
tJ
Adjust the PROCESSOR-OUT control so that the
meter deflection is within the ALC zone.
CAUTION: - - - - - - - - - - - - - - - - -
The TS-940S may be operated at full power for no more
than 1 hour with the transmitter keyed continuously. If
transmissions longer than one hour are necessary, use the
RF POWER control to reduce the output level of the
TS-940S to 50 watts or less.
I]
Operate the RTIY keyboard.
17