Kenwood TS-940S Instruction Manual page 15

AGC switch @(page 25) - - - - ,
OFF- Used to disable the AGC. (Turns
OFF the S-Meter function).
NOTCH control @(page 22)
PITCH control
®
(page 26)---,
Allows variation of the receiving tone
of CW to any desired pitch.
FAST- Normally used for CW and FSK.
SLOW- Normally used for SSB, AM
and FM.
Used to attenuate interference caused
by heterodyne type signals. This con-
trol is not effective in reducing interfer-
ence caused by SSB, FM, or AM type
signals.
AF TUNE control@(page
26)
.-----1 This control is used to accentuate or
peak the desired CW signal.
CW VBT control @(page 21)
Used to control the effective CW pass-
~---------1
bandwidth. Counterclockwise rotation
reduces the passbandwidth.
TRANSMISSION
II
Using shielded line, connect a key or keyer to the CW
KEY jack on the rear panel.
Key plug connection Caution:
• Tum on the power.
When using an electric keyer, check
the polarity of the key jack is
as shown .
• The meter lamp lights and a frequency is shown on
the display.
• Set the MODE to CW.
• Set the METER switch to ALC .
• Tum the PWR control fully clockwise .
• Set the standby switch to SEND, if you are not using
Semi-Break in.
Ill
Depress the key.
Note: --------------------------------
With the VOX switch ON, pressing the key down
permits transmission even with the standby switch
set to REC. This is called Semi-break-in operation.
(See page 23)
II
Adjust the CAR LEVEL control on the top cover so
that the meter deflection is within the ALC zone.
ALCzone
II
After transmission set the standby switch to REC.
Note: --------------------------------
The frequency display shows the transmit carrier
frequency.
11