Quick User Guide To Main Alarm Control Operations By The Keypad - DSC WP8033 Installer's Manual

Quick User Guide to Main Alarm Control Operations by
The Quick Start Guide is intended for the user of the system. Please remove
this detachable sheet and hand it to the user.
Arming and Disarming the System
Step Operation
1 Press the Partition Selection
button and then select a
PARTITION
(if Partition is enabled)
2 Arm AWAY
Arm HOME
Disarm (OFF)
Quick arm AWAY
(If Quick Arm is enabled)
Quick arm HOME
(If Quick Arm is enabled)
Forced arming AWAY
(system not ready)
Forced arming HOME
(system not ready)
3 INSTANT
LATCHKEY
Note: The factory default master user code is 1111. The code is not required if quick arming has been permitted by the
installer. Change the factory default code to a secret code without delay.
Initiating Alarms
Alarms
Emergency alarm
Fire alarm
Panic alarm
D-306048 WP8033 Installer's Guide
the Keypad
followed by any combination of
+ [
+ [
+ [
+ [
to silence the "protest" buzzer
+ [
to silence the "protest" buzzer
(After arming HOME/AWAY)
Actions
When pressing the Fire or Emergency icons, the keypad
( 2 sec.)
starts beeping. After pressing the button for approx. 2
seconds, the keypad sends the command.
( 2 sec.)
( 2 sec.)
User Actions
] or enter code
] or enter code
] or enter code
] or enter code
] or enter code
Notes
Key & Keypad
Response
The selected key blinks.
The selected key and the
"Present Prox Tag" LED (
) begin to blink and
prompt you to present
your Tag or enter your
user code.
The keypad's LED blinks
red once to indicate
transmission of the
arming command to the
control panel.
The LED and the buzzer
then indicate the control
panel's response.
23