Installing The Plink3 Dsc - DSC WP8033 Installer's Manual

3.7 Installing the PLINK3 DSC

The PLINK3 DSC is used to view and control the WP8033 system over the Internet.
Perform the following instructions for the PLINK3 DSC installation.
Note: PLINK3 DSC operation is not backed up
by the control panel's battery and it is shut down
during AC failure.
1. Mount the internal PLINK3 DSC into the back
unit and fasten it with 2 screws.
2. Connect the flat cable (B) from the front panel
to the PLINK3 DSC, as follows: Connector B1
to the front panel; connector B2 to the
PLINK3 DSC.
3. Connect the Cat-5 cable from the PLINK3
DSC to the home router.
Note: In order to prevent interference to the
antenna, do not route the Cat-5 cable through
the cable entry knockout on the right side of
the panel.
A. Cat-5 cable to home router
B. Flat cable
B1. This side for front unit
B2. This side for PLINK3 DSC
12
Figure 3.7 – PLINK3 DSC Mounting
D-306048
WP8033 Installer's Guide