IBM 9006-22C Installing And Configuring page 43

3. Depending on the memory locations, you might need to remove the system processor air baffle.
Carefully unsnap and lift the processor air baffle from the system.
4. Push the DIMM locking tabs away from the socket.
5. Insert the memory DIMM.
a) Grasp the memory DIMM along its edges and align it with the slot on the system backplane.
Attention: Memory is keyed to prevent it from being installed incorrectly. Note the location
of the key tab within the memory connector before you attempt to install it.
b) Press firmly on each side of the memory DIMM as shown in Figure 23 on page 29 until the locking
tab locks in place with an audible click.
Figure 23. Inserting the memory DIMM
6. If you removed the system processor air baffle, replace it.
Insert the edge of the air baffle into the fan support. Then, carefully press the air baffle down into
place.
Installing and configuring your system and system features 29