IBM 9006-22C Installing And Configuring page 32

Figure 15. Disk drive lock detail
8. If you installed an NVMe drive, power the system back on.
For instructions, see "Starting the 5104-22C, 9006-12P, 9006-22C, or 9006-22P system " on page
108.
9. For a non-RAID drive, configure the installed drive for your environment. If the drive is part of a RAID
configuration, skip this step, the drive is detected and configured when inserted.
After you insert the new drive, you need to rescan for the device.
Ubuntu Linux operating system
To run the rescan-scsi-bus command in the Ubuntu Linux operating system, log in to the
system as the root user, and run the following command:
rescan-scsi-bus
The rescan-scsi-bus tool is available in the scsitools package; install the package by using
the following command:
sudo apt-get install scsitools
18 Power Systems: Installing and configuring the IBM Power System LC922 (9006-22P)