Installing The Fan Tray - Siemens RUGGEDCOM MX5000RE Installation Manual

RUGGEDCOM MX5000RE
Installation Guide
6. Place one exterior tooth lockwasher on the inside grounding stud found on the right side of the RUGGEDCOM
MX5000RE.
7. Attach the free end of the grounding cable to the inside grounding stud using two hex nuts.
8. Carefully pass the PS1 power supply cable assembly through opening E on the bottom of the RUGGEDCOM
MX5000RE.
9. Carefully pass the PS2 power supply cable assembly through opening G on the bottom of the RUGGEDCOM
MX5000RE.
NOTE
When aligning the patch panels, the inside grounding stud should be toward the back of the
RUGGEDCOM MX5000RE.
10. Apply Loctite® 242 to four SS304 truss head philips drive screws.
11. Secure both patch panels to the RUGGEDCOM MX5000RE with four SS304 truss head philips drive screws.
Section 2.10

Installing the Fan Tray

To intall the fan tray, do the following:
1. Position the fan tray the DB25 connectors facing forward when the fan tray is in the RUGGEDCOM MX5000RE.
2
1
Figure 16: Fan Tray Installation
1. #8-32×5/16" Pan Head Screw 2. Fan Tray
Installing the Fan Tray
Chapter 2
Installing the Device
21