Show Monitor Items As A Trend Plot; Change Parameter Settings - Omron Q2A Series Technical Manual

4.5 Keypad Operation
7.
Push to keep the changes.
The configuration procedure is complete.
◆

Show Monitor Items as a Trend Plot

The procedure in this section shows how to show the selected monitor data as a trend plot.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
The screen will show the monitors as shown in this figure.
Note:
(Hold) to switch between Pause and Restart for the monitor display. The "Hold (ENTER)" message flashes while monitoring
Push
is paused.
◆

Change Parameter Settings

Do the steps in this procedure to set parameters for the application. This example shows how to change the setting
value for C1-01 [Accel Time 1].
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
6.
Push or
134
) to show the HOME screen.
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Trend Plot], then push
) to show the HOME screen.
, push ( ) to show [
to select [Parameters], then push
to select [C: TUNING], then push
to select [C1: ACCEL / DECEL], then push
to select C1-01, then push
] on .
.
.
] on .
.
.
.
.
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual