Install Chassis Into Rack Or Cabinet - Dell Force10 S55 Manual

Follow these steps to attach the brackets to the chassis:
Step Task
Take the brackets and screws out of their packaging.
1
Attach the brackets to the sides of the chassis at the PSU end, using four screws for each bracket. Attach the
2
bracket so that the "ear" faces to the PSU and the outside of the chassis.
View from Chassis Rear
View from Chassis Front
Power Supply/Fan Module

Install chassis into rack or cabinet

Ensure that there is adequate clearance surrounding the rack or within the cabinet to permit access and
airflow. Follow the steps below to install a switch into a two-post 19-inch equipment rack, using the
already attached mounting brackets.
Step Task
Dell Force10 recommends that one person hold the S55 chassis in place while another attaches the brackets to the
1
posts.
18 | Install the S55
Power Supply/Fan Module
Screws
Screws
Connect to
Rack/Cabinet
(ears)
Connect to
Rack/Cabinet
(ears)