Dell Force10 S55 Manual page 43

Dell Force10 products, which fall within the scope of the WEEE, are labeled with the crossed-out
wheelie-bin symbol, as shown above, as required by WEEE.
For information on Dell Force10 product recycling offerings, see the WEEE Recycling instructions on
iSupport at: https://www.force10networks.com/CSPortal20/Support/WEEEandRecycling.pdf.
For more information, contact the Dell Force10 Technical Assistance Center (TAC).
SD card removal
The SD card can be removed and re-installed, to support high security environments. Dell Force10
recommends the card be removed only when necessary. It should only be removed and replaced by
authorized personnel.
CAUTION: The SD card should only be removed to support high security operations and after discussions
with Dell Force10 Technical Support or your Dell Force10 representative.
To open the case:
Remove the small phillips screws that connect the top to the body. There are three screws evenly
1
spaced across the rear and three screws evenly spaced along each side.
Slide the top backwards until its front flange slides free of the faceplate, then lift it off.
2
Remove the small screw at the top of the SD card slot.
3
Gently push the SD card to release it from the slot.
4
Remove the card.
5
Battery replacement
The lithium battery is not field replaceable. It should only be removed and replaced by authorized
personnel. Contact Dell Force10 Technical Support for assistance if the battery requires replacement.
WARNING: Always wear an ESD-preventive wrist or heel ground strap when handling the S55 and its
components. As with all electrical devices of this type, take all the necessary safety precautions to prevent
injury when installing this system. Electrostatic discharge (ESD) damage can occur if components are
mishandled.
To open the case:
Remove the small phillips screws that connect the top to the body. There are three screws evenly
1
spaced across the rear and three screws evenly spaced along each side.
S55 Specifications | 43