Messages In The Cycles - Siemens SINUMERIK 840D Programming Manual

5
03.96
09.01
5.4

Messages in the cycles

The cycles output messages in the dialog line of the
control. These messages do not interrupt
processing.
They provide information about specific cycle
behavior and how machining is progressing and are
usually displayed for the duration of the machining
operation or until the end of the cycle. The following
messages can be displayed:
Message text
"Depth: According to value for relative depth"
"Machining elongated hole"
"Machining slot"
"Machining circumferential slot"
"Wrong mill direction: G3 will be generated"
"Changed form of the undercut"
"1st drilling depth: According to value for relative
depth"
"Caution: Final machining allowance ≥ tool diameter!"
"Thread: – longitudinal thread machining"
"Thread: – transversal thread machining"
"Simulation active, no tool programmed, final
contour being traversed"
"Simulation active, no tool programmed"
"Waiting for spindle reversal"
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Error Messages and Error Handling

5.4 Messages in the cycles

Source
CYCLE81 ... CYCLE89, CYCLE840
LONGHOLE
SLOT1
SLOT2
SLOT1, SLOT2, POCKET1, POCKET2,
CYCLE90
CYCLE94, CYCLE96
CYCLE83
POCKET1, POCKET2
CYCLE97, CYCLE98
CYCLE97, CYCLE98
POCKET1...POCKET4,
SLOT1, SLOT2, CYCLE93,
CYCLE72
CYCLE71, CYCLE90, CYCLE94, CYCLE96
CYCLE840
5
n
5-355