Operating Instructions - Siemens SINUMERIK 840D Programming Manual

3
12.97
11.02

3.16.2 Operating instructions

• If the rotary axes of machine kinematics are defined
as the manual axes (CYCLE800 start-up menu), the
swivel angle to be set is displayed in cancel alarm
62180/62181.
After rotation to the swivel angle, the NC program is
continued with NC Start.
• It is possible to traverse the axes in the active swivel
plane in JOG mode if key WCS is active on the
machine control panel. This ensures that the
geometry axes are traversed and not the machine
axes.
• It is possible (without operator support) to deselect
the swivel data record and cancel the swivel frame
(WPFRAME, PARTFRAME, TOOLFRAME) by
programming CYCLE800().
• In CYCLE800, parameters can also be transferred
as input values (e.g. result variable of measuring
cycles _OVR[19]).
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)
3
Milling Cycles
3-233