Siemens SINUMERIK 840D Programming Manual page 239

3
12.97
11.02
MD No. MD identifiers
20152 $MC_GCODE_RESET_MODE[41]
20152 $MC_GCODE_RESET_MODE[51]
20152 $MC_GCODE_RESET_MODE[52]
20180 $MC_TOCARR_ROT_ANGLE_INCR[0]
20180 $MC_TOCARR_ROT_ANGLE_INCR[1]
20182 $MC_TOCARR_ROT_ANGLE_OFFSET[0] 0
20182 $MC_TOCARR_ROT_ANGLE_OFFSET[1] 0
20184 $MC_TOCARR_BASE_FRAME_NUMBER -1
22530 $MC_TOCARR_CHANGE_M_CODE
24006 $MC_CHSFRAME_RESET_MASK
24008 $MC_CHSFRAME_POWERON_MASK
28082 $MC_MM_SYSTEM_FRAME_MASK
30455 MISC_FUNCTION_MASK
Setting data
SD no. SD identifier
42980 $SC_TOFRAME_MODE
Changes to the relevant machine data result in
reorganization of the buffered memory (data loss!).
Series start-up must be performed after setting the MD
and before NCK reset.
References:
1) For note on machine data, see this page and the next
Note on MD 10602:
If after TRAORI, the ZO is not to be reprogrammed. e.g. for
tool correction.
Note on MD 11450/MD 20108:
Activate PROGEVENT after block search
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)
/IAM/ HMI/MMC Installation and Start-Up Guide
Value Comments
1)
0 (default)
0 (default)
1)
0 (default) 1)
0 (default)
1)
0 (default)
1)
1)
(default)
1)
(default)
1)
(default)
1)
0
Bit 4=1 if system frame WPFRAME is to
remain active after a reset
Bit 4, 3, if system frames PAROT, TOROT,
2=1 WPFRAME are to be cleared on
power ON
Bit 4, 3, Setting up system frames
2=1
Bit 2, for rotary axes defined as modulo
1)
0=1 axes
Value Comments
3 kinematics type "T" and "M" only
3
Milling Cycles
Can be
changed
G
V
V
G
G
G
G
G
V
V
V
G
V
Can be
changed
V
3-239